Collaborative Post¦ When choosing the most appropriate carpet cleaning method, we need to pay attention to several important factors. The type of carpet, the degree of soiling of the carpet, the available drying time and possibly the use of pre-treatment agents must be taken into consideration. After clarifying these requirements, the correct domestic carpet cleaning method can be selected.
If you don’t want to clean the carpet yourself, or have concerns about doing so, then hire a professional carpet cleaning company such as Dr. Chem-Dry – a Phoenix carpet cleaning company – to do the job. Otherwise, continue reading!
A powerful vacuum cleaner is the best choice for basic carpet cleaning. In most households it is completely enough if the dirt is removed once or twice a week with a vacuum cleaner. For carpets with a long pile, it is recommended to switch off the vacuum cleaner brushes. Otherwise, it is possible that the carpet is sucked into the device. In the worst case, it can even be damaged. Carpets that have a short pile can be cleaned very effectively with a vacuum cleaner that has rotating brushes. These brushes are able to remove the dirt from the carpet and then vacuum it up. So dirt and lint cannot even get stuck in the pile.
This well known method gives excellent results. A special cleaning powder is required for this type of cleaning. It can be used to clean certain areas as well as the entire carpet. Most powders just need to be sprinkled on the carpet and worked in a little. After a certain amount of time, the cleaning powder can then easily be collected with a vacuum cleaner. The dirt is also sucked in with the powder. This method works well to get deeper dirt out of the carpet. However, using the cleaning powder can also cause discolouration, especially if the carpet is very sensitive. In such a case, it is always better to test the application in an inconspicuous place.
The principle of cleaning the carpet with foam is very similar to deep carpet cleaning with powder. However, this method takes a little longer. First, the floor should be vacuumed thoroughly. Then the foam is sprayed on and worked in with a brush. Then the foam is left to dry. Once it is completely dry, it can easily be vacuumed with a vacuum cleaner. Before using the carpet foam, it is important to determine whether the carpet will not be damaged. For this purpose, some of the carpet foam is sprayed on and worked in at a location that cannot be seen. After drying, it is suctioned off. The spot should then be really clean, but it shouldn’t make a bleached impression. If the colour of the treated area is lighter than the original colour of the carpet after the trial treatment, further use should be avoided. In this case, the carpet foam is not suitable for this carpet.
In many households, carpets have a lot of stains that are difficult to be removed without professional carpet cleaning procedures. When there are children and pets living there, expert carpet cleaning services should be used 3-4 times a year. Steam carpet cleaning services are the best choice in this situation. The hot water vapour loosens the dirt that would otherwise remain stuck in the carpet. Then, the device absorbs the resulting liquid and dirt at the same time. Both get into a water filter, which is simply emptied after cleaning. Steam vacuum cleaners are not cheap at all, so instead of buying such an expensive device, you should schedule a hot water extraction carpet cleaning procedure.
